Canon imageRUNNER ADVANCE C5051 Getting Started page 69

● If you want to specify a Community Name 1
☐ Press [Set Community Name 1] → [On] → specify the settings for <MIB Access Permission> and the community name in
[Community Name].
You can also change the community name in [Community Name] to a name other than 'public' .
● If you want to specify a Community Name 2
☐ Press [Set Community Name 2 ] → [On] → specify the settings for <MIB Access Permission> and the community name in
[Community Name].
You can also change the community name in [Community Name] to a name other than 'public2' .
2
Specify the settings for SNMP v . 3 .
[On] for <Use SNMP v. 3>: Specify the user and context according to the following procedures.
An SNMP v. 3 user with the following settings is registered by default. Delete or change these settings as necessary.
- User: initial
- MIB Access Permission: Read/Write
- Security Settings: Auth. Yes/Encry. Yes
- Authent. Algorithm: MD5
- Authent. Password: initial
- Encryption Algorithm: DES
- Encryption Password: initial
● If you want to add an SNMP v . 3 user:
☐ Press [User Settings] → [Register] → specify the user name, MIB permissions, and security settings.
If you select [Auth. Yes/Encry. Yes] from the Security Settings drop-down list, it is necessary to set the authentication algorithm and
the encryption algorithm. Select the authentication algorithm → enter the authentication password. Next, select the encryption
algorithm → enter the encryption password. If you select [Auth. Yes/Encry. No] from the Security Settings drop-down list, select the
authentication algorithm → enter the password for authentication.
Communication Environment Setup
3
3-9