(2) Developer section
(2-1)Detaching and reattaching the developer unit
Procedures
1. Open the front cover (a).
2. Push down the developer release lever
(b).
3. Detach the developer unit (a).
4. Check or replace the developer unit (a),
and then reattach the parts which are
detached in the original position.
Attention:
Execute the following maintenance modes
when replacing the maintenance kit.
(LCD model)
Executing "Maintenance" (See page 6-11)
Executing "Developer" (See page 6-12)
(LED model)
Installing the toner installation mode
(See page 6-17)
Maintenance counter preset
(See page 6-17)
a
Figure 4-12
a
Figure 4-13
4-10
2RV/2RW/2RX/2RY/3RA
b
b