Kyocera ECOSYS P2235dw Service Manual page 241

Content of Jam Code
J0000: Power ON jam
The power was turned on while the unspecified conveying sensor turns on.
Step Check description
1 Checking the paper path
2 Cleaning the sensor
3 Checking the connection
4 Replacing the sensor
J0101/J0104/J0105/J0106: Paper jam caused by the software factor
The firmware does not properly activate.
Step Check description
1 Resetting the main power
2 Firmware upgrade
J0107: Fuser temperature stabilization time-out
The fuser temperature does not achieve to the paper feed-able temperature within the specified time.
Step Check description
1 Resetting the main power
2 Changing the external
power source
3 Changing the settings
Assumed cause
The paper is caught with a
piece of paper, etc.
The sensor is dirty.
The sensor is not properly
connected.
The sensor is faulty.
Assumed cause
The controller does not
activate properly.
The firmware does not
properly activate.
Assumed cause
The controller does not
activate properly.
The electric power supply
fluctuates or the electric
voltage reduces.
The actual paper and the
paper settings (media
type, paper size) do not
match.
7-34
2RV/2RW/2RX/2RY/3RA-3
Measures
If there is a paper piece, for-
eign object or burr on the part
such as guide and actuator
on the conveying path,
remove it.
Clean the registration sensor
or exit sensor.
Reconnect the connector to
the registration sensor or exit
sensor.
Replace the high voltage
PWB (including the registra-
tion sensor) or fuser unit
(including the exit sensor).
Measures
Turn off the power switch and
unplug the power cord. After
5s passes, reconnect the
power cord and turn on the
power switch.
Upgrade the firmware to the
latest version.
Measures
Turn off the power switch and
unplug the power cord. After
5s passes, reconnect the
power cord and turn on the
power switch.
Plug the power cord into
another wall outlet.
Select the proper media type
in the system menu.
Reference
Reference
Reference