6. Remove four screws(M3x8S tight)(a),
detach MP below frame(b).
7. Pull the lock lever and the slide the
paper feed roller shaft (b) to the right.
8. Detach the paper feed pulley (c).
9. Check or replace the paper feed pulley
(c), and then reattach the parts which
are detached in the original position.
*: When attaching the paper feed pulley,
locate it so that the cross notch lies at the
right side viewed from front.
Figure 4-9
a
Figure 4-10
Figure 4-11
4-9
2RV/2RW/2RX/2RY/3RA
a
b
b
c