Observa Telecom LTE CPE SQI4N4 Quick Start Manual page 36

802.11b/g
802.11b
802.11g
4. Set the Channel No. from 1 to 11.
5. Click Submit. As shown in Figure 4‐1.
4.1.2 WPS Settings
Wi‐Fi Protected Setup (WPS) enables you to simply add a wireless client to the network
without needing to specifically configure the wireless settings, such as the SSID, security
mode and passphrase. You can use either the WPS button or PIN to add the wireless client.
To configure Wi‐Fi WPS settings, perform the following steps:
1. Choose Wi‐Fi > WPS Settings.
2. Set WPS to Enable.
3. Click Submit. As shown in Figure 4‐2.
4.2 Setting SSID Profile
After you configure the CPE on the SSID Profile page, the Wi‐Fi client connects to the CPE
based on preset rules, improving access security.
To configure the CPE on the SSID Profile page, perform the following steps:
1. Choose Wi‐Fi > Wi‐Fi Settings.
2. Set SSID.
The SSID can contain 1 to 32 ASCII characters. It cannot be empty and the last character
cannot be a blank character. In addition, the SSID cannot contain the following special
characters: / ' = " \ &
encryption mode is required.
The Wi‐Fi client can connect to the CPE in
802.11b or 802.11g mode.
The Wi‐Fi client can connect to the CPE in
802.11b mode.
The Wi‐Fi client can connect to the CPE in
802.11g mode.
Figure 4‐1
Figure 4‐2