Transmitter Calibration; Frequency Selectable 5.8Ghz - Hubsan H502S Instruction Manual

9. TRANSMITTER CALIBRATION

Mode 2: Push both sticks to the upper left corner and power on the transmitter
simultaneously,rotate both sticks in circles for twice, then press any trim for 1.5 second until
the LED on the transmitter turns in solid green which indicating a successful calibration.
Mode 1: Push the left stick to the upper left corner and the right stick to the upper right corner
and power on the transmitter simultaneously, rotate both sticks in circles for twice, then press
any trim for 1.5 second until the LED on the transmitter turns in solid green which indicating a
successful calibration.
!
The transmitter mode can be shifted according to the above operation.

10. FREQUENCY SELECTABLE 5.8GHZ

The transmitter will automatically find the best frequency to ensure a live video with good
quality of transmission. Please re-select the frequency from 5730MHZ to 5845MHZ to get a
better video transmission when necessary.
Pull the throttle stick to the lowest position and press the Elevator stick for 1.5 second to enter
into the MAIN MENU interface. Push the Elevator stick up/down to select "5.8G Frequency",
push the stick to the right to enter into the " 5.8G frequency" interface, select a matched
frequency.
0:08:49
M2
Set Reverse
Set Sensitivity
5.8G Frequency
Set Manual
©
17
2015 Hubsan
哈博森科技 版权所有
MAIN MENU
Exit
0:08:49
M2
5.8G FREQUENCY
Exit
5730MHZ