Failsafe Mode; Conditions Which Activate The Failsafe Mode - Hubsan H502S Instruction Manual

Press the Elevator stick for 0.5 second to switch on/ off follow me mode.
Press the stick to enter into the follow me Mode, indicated by two "beeps" sounds, the
" Follow On" displays on the LCD and the drone will turn and face to the
transmitter.
Press the stick again to exit follow me Mode, indicated by one "beep" sound and the
" Follow Off" displays on the LCD .
The follow me mode only works when the GPS both on transmitter and on drone with
!
no less than 6 satellites.
The follow me mode will be exited when you push/press any keys on transmitter
except the throttle.

6.5 FAILSAFE MODE

The quad copter will enter into failsafe mode when the connection is lost from the transmitter.
The flight control system will control the quad copter to return to the HOME POINT and landing
automatically. The failsafe mode help to aviod injuries or damages.

CONDITIONS WHICH ACTIVATE THE FAILSAFE MODE

(1) Transmitter is power off.
(2) The flight distance is beyond the effective distance of the transmitter's signal transmission.
(3) The transmitter's signal was interrupted by some other strong electronic interference.
To ensure that the X4 can return safely to its home point when signal is lost, fly the
X4 in the safe flight area.
If the quantity of GPS satellites drops below six for more than 20 seconds while the
X4 is returning to home, the X4 will descend automatically.
The X4 will not avoid obstacles automatically while in failsafe mode. You must set the
height value to avoid obstacles in the flight path.
©
2015 Hubsan
11
哈博森科技 版权所有