Quad Copter Motor Led Indicator; Quad Copter Battery; Install The Battery; Charging - Hubsan H502S Instruction Manual

2. QUAD COPTER MOTOR LED INDICATOR

Indicator Status:
Front LED: in blue; Back LED: in red.
1. Power on: 4 LED indicators blink simultaneously every 1.5 seconds.
2. GPS Flight: 4 LED indicators keep lighting.
3. GPS Return : 2 front LED keep lighting, and 2 back LED explosion-flashing every 2
seconds.
4. Headless Flight: 2 front LED explosion-flashing every 2 seconds., and 2 back LED keep
lighting.
5. Low Power Return: 2 front LED keep lighting, and 2 back LED explosion-flashing every 5
seconds.
6. Photo: 2 front LED keep lighting, 2 back LED blink once.
7. Video: 2 front LED keep lighting, 2 back LED blink alternately.
8 . LED indicators can be turned off when taking pictures and videos.

3. QUAD COPTER BATTERY

3.1 INTRODUCTION
The quad copter battery is a rechargeable lipo battery with 610mAh capacity and 7.4V voltage.
The battery should only be charged with the HUBSAN charger.
Please make sure the battery being fully charged before the first time use.

3.2 INSTALL THE BATTERY

Push the battery into the battery compartment
correctly and connect the battery plugs in
correct polarity. Close the battery compartment
cover.

3.3 CHARGING

Connect the battery to the USB charger, then
connect the USB charger to the USB devices,
such as computer or mobile power.
It takes around 40 to 50 minutes to fully charge
the battery by 500mA current. The USB
LED indicator is in red when charging and will
lights off when the battery is fully charged.
Please unplug the charger and battery when
the charging is completed.
Please fully charge the batteries to avoid disconnection due to the low voltage.
©
2015 Hubsan
04
哈博森科技 版权所有