Sensitivity Setup; Install The Tx Battery; Reversing Channel Setup - Hubsan H502S Instruction Manual

7.2 INSTALL THE TX BATTERY

PUSH
Remove the cover
● Do not mix old and new batteries
● Do not charge non-rechargeable battery.

7.3 REVERSING CHANNEL SETUP

If you would like to reverse any of the stick functions due to personal preference then follow
the instructions below. Be aware that it will change the controls back to front.
Pull the throttle stick to the lowest position and long press the Pitch stick simultaneously to
enter into MAIN MENU interface. Push the Elevator stick up/down to select "Set Reverse".
Select the "Exit" to exit.
0:08:49
M2
MAIN MENU
Set Reverse
Set Sensitivity
5.8G Frequency
Set Manual
Exit

7.4 SENSITIVITY SETUP

If you would like to change the sensitivity of any of the stick functions then follow the
instructions below.
Pull the throttle stick to the lowest position and long press the Elevator stick to enter into the
MAIN MENU interface. Push the Elevator stick up/down to select "Set Sensitive", push the
stick right to enter into the " set sensitive" interface, select "Expert mode" or " Normal mode".
Select" Exit" to exit.
Install 4 x AA batteries
according to the correct polarities
● Do not mix different types of batteries
0:08:49 M2
SET REVERSE
Exit
Elevator
Aileron
Rudder
PUSH
Close the cover
Normal
Normal
Normal
©
14
2015 Hubsan
哈博森科技 版权所有