7.2 INSTALL THE TX BATTERY
PUSH
Remove the cover
● Do not mix old and new batteries
● Do not charge non-rechargeable battery.
7.3 REVERSING CHANNEL SETUP
If you would like to reverse any of the stick functions due to personal preference then follow
the instructions below. Be aware that it will change the controls back to front.
Pull the throttle stick to the lowest position and long press the Pitch stick simultaneously to
enter into MAIN MENU interface. Push the Elevator stick up/down to select "Set Reverse".
Select "Exit" to exit.
0:08:49
M2
MAIN MENU
Set Reverse
Set Sensitivity
5.8G Frequency
Set Manual
Fly When no GPS
Show Version
Exit
7.4 SENSITIVITY SETUP
If you would like to change the sensitivity of any of the stick functions then follow the
instructions below.
Pull the throttle stick to the lowest position and long press the Elevator stick to enter into the
MAIN MENU interface. Push the Elevator stick up/down to select "Set Sensitivity", push the
stick right to enter into the " set sensitivity" interface, select "Expert mode" or " Normal
mode".
Select" Exit" to exit.
Install 4 x AA batteries
according to the correct polarities
● Do not mix different types of batteries
0:08:49
M2
SET REVERSE
Exit
Elevator
Aileron
Rudder
PUSH
Close the cover
Normal
Normal
Normal
14
©
2016 Hubsan