Table of Contents
Advertisement
3. Attach the bracket with 10-32, flat-head Phillips screws (4) using the two
4. Repeat
Figure 23: Installing the rack-mounting brackets on the switch
5. Locate the two rear mounting brackets in the shipping carton.
6. Position a rear mounting bracket (3) so that the bracket's center holes (1)
Note:
7. Secure the rear mounting bracket to the switch using two 10-32, flat-head
8. Repeat
Finalize the Rack-Mounting Procedure
Use the following sections to complete the installation procedure.
After completing the steps outlined in the previous sections, install the switch in
the rack as follows.
Director 2/64 Installation Guide
center threaded holes on the front side of the switch.
step 2
and
step 3
line up with the 1st and 3rd threaded holes on the back portion of the switch
side.
The slotted end (
) of the bracket should face toward the back of the switch.
2
Phillips screws.
step 6
and
step 7
Installing and Configuring the Director
for the second front mounting bracket.
for the second rear mounting bracket.
61
Advertisement
Table of Contents
