Table of Contents
Advertisement
Changing the Director's IP Address
If multiple directors are installed, or a public LAN segment is used, network
addresses must be changed to conform to the customer's LAN addressing scheme.
The following items are required to perform this task:
Use the following steps to verify or change (if required) a director IP address,
subnet mask, or gateway address:
1. Remove the protective cap from the 9-pin maintenance port at the rear of the
Director 2/64 Installation Guide
A local workstation (desktop or notebook computer) with:
— Microsoft Windows 98, Windows 2000, Windows 2003, Windows XP,
Windows Millennium Edition, or Windows NT 4.0 operating system
— RS-232 serial communication software (for example, ProComm Plus or
HyperTerminal)
Note that the HAFM appliance may be used for this function and that
HyperTerminal is included in Windows 2000 provided in the HAFM
appliance.
An asynchronous RS-232 null modem cable (supplied with the Director 2/64)
director (a flat-tip screwdriver may be required). See
Installing and Configuring the Director
1.
Figure 31
71
Advertisement
Table of Contents
