Power Lead; Positioning The Air Conditioner - Telair 5400H Manual For Installation And User Manual

Fix a reinforcement frame around the
opening (fig. 5).

4.2.3 Power lead

A 3-core cable with a 2.5 mm² cross-section
(live-neutral-earth) must be routed for the
power supply of the air conditioner. The wires
at one end must be connected to the thermal
magnetic circuit breaker (recommended load
10 A) previously installed in the vehicle's
electrical distribution panel exclusively for the
air conditioner. The other end should reach
the opening made in the roof of the vehicle
and protrude from the hole in the reinforcing
frame by approximately 50 cm in order to
1
facilitate connection to the air conditioner
(Fig. 6).
The electrical
protected in order to ensure its integrity and
insulation in all conditions of use of the
vehicle.
2
4
4.3

Positioning the air conditioner

Before installation, check that the
cylindrical
conditioner
positioned inside its special frame seat
(Fig. 7 ref. 1).
Before positioning the air conditioner on the
vehicle roof it is necessary to lay a sufficient
amount of slow-drying sealant around the rim
of the aperture.
Bring the air conditioner onto the roof (fig. 7
ref. 2) and, without scraping it, position it
5
over the 395 x 395 mm opening previously
lined with sealant. Correct alignment of the
air conditioner on the roof will provide a view
- from inside the camper - of the 4 threaded
fixing seats.
The arrow in fig. 7 indicates direction of
forward drive.
9
cable must be
section seal on
base is still
suitably
6
the air
correctly