Source Audio Nemesis Delay User Manual page 22

If trails mode is active, the ON/OFF LED will be lit green when the delay effect is active and lit red
when the delay effect is bypassed.
Trails Mode
Trails mode is an optional bypass mode that allows the repeats to fade out naturally even after the
delay has been bypassed.
Trails mode can be enabled from the Hardware Options menu in the Neuro App or using the
hardware by pressing the O
between enabling and disabling trails mode and the setting will be saved automatically. Trails Mode
is a global setting and is NOT saved per preset. However, when using Trails Mode, both trails and
hardware bypass are always accessible:
If trails mode is active, tap the O
and hold the O /O
N FF
more information, see
Tap Tempo Footswitch
Press the T F
AP OOTSWITCH
toggle switch allows subdivisions to be selected:
• If the S S
UBDIVISION WITCH
duration between taps on the T
• If the S S
UBDIVISION WITCH
to 3/4 the duration between taps on the T
and get a delay time that is a dotted eighth note relative to that duration.
• If the S S
UBDIVISION WITCH
duration between taps on the T
delay time that is a triplet relative to that duration.
The S S
UBDIVISION WITCH
certain delay time has been dialed in with the S
can flip to the dotted eighth note position to multiply the delay time by 3/4, or flip to the triplet
position to multiply the delay time by 1/3.
Tempo LED
The T LED above the T
EMPO
blink once per beat even if a tap subdivision is selected using the S
T LED will always blink at the same rate as the user's foot taps used to input the tempo.
EMPO
Hold Mode
The HOLD function on the Nemesis will freeze the current contents of the delay line and continue to
circulate the audio infinitely while the HOLD function is engaged. To activate HOLD, press and hold
the TAP footswitch while the effect is engaged. When HOLD is activated, no new audio will be sent to
the delay effect. The dry signal will continue to pass through normally. While HOLD is active, the TAP
SA260
/O F
N FF OOTSWITCH
/O F
N FF OOTSWITCH
F for half a second to do a hard bypass (relay or buffer bypass). For
OOTSWITCH
TM
Universal Bypass .
two or more times to input the delay time. The corresponding S
is in the left position (quarter notes), the delay time will be equal to the
F
AP OOTSWITCH
is in the center position (dotted eighth notes), the delay time will be equal
AP
is in the right position (triplets), the delay time will be equal to 1/3 the
F
AP OOTSWITCH
can also create subdivisions of the delay time together with the T
F indicates the current tempo, blinking once per beat. It will
AP OOTSWITCH
Nemesis Delay User's Guide
while holding the C
ONTROL
quickly to do a soft bypass (with trails) and press
.
F H. This allows the user to tap in quarter notes
OOTSWITC
. This allows the user to tap in quarter notes and get a
S in the quarter note position, you
UBDIVISION WITCH
UBDIVISION
I B . This will toggle
NPUT UTTON
UBDIVISION
K
IME NOB
S ; that is, the
WITCH
. If a
22