Source Audio Nemesis Delay User Manual page 31

6. Move the knob(s) you wish to control with the expression pedal to the maximum desired
position, then click the O
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Note: The parameter range can be inverted by swapping the minimum and maximum position of the
knobs during steps 5 and 6.
Note: To cancel a control assignment, press the CONTROL INPUT button at any time during the
process above.
Note: if you want to use the default Input Volume Control function but calibrate the range of an
expression pedal, do the procedure above but cancel the assignment after step 4 by pressing the
CONTROL INPUT button. The pedal calibration will be retained but no mapping to knobs will be
created.
Once a mapping is created, it can be stored as part of a user preset. This way, each preset can be
configured to have its own custom mapping.
External Control can be toggled on/off at any time by pressing the CONTROL INPUT button.
Reset Expression Control Mapping
To clear the expression control mapping (Expression or Hot Hand), first press the C
B to turn OFF control mode. The C
UTTON
I B until the C
NPUT UTTON
resets external control back to the default Input Volume Control.
External Switch used as Expression Input (Expression "Toggle")
An external switch can also work as a sort of expression pedal that only has two positions: on and off.
The external switch can be either momentary or latching.
Expression Toggle Connected to Pedal In
To use this mode, connect an external switch to P
position instead of the SWITCH position. The following plug configuration is required:
Follow these steps for configuration:
1. Press the C
ONTROL
2. Press and hold the C
(approximately one blink per second).
SA260
/O F
N FF OOTSWITCH
ONTROL
L blinks 3 times. This clears all expression or Hot Hand mapping and
ONTROL ED
Ground Power (Switch pull-up)
I B to enable external control. The C
NPUT UTTON
I B
ONTROL NPUT UTTON
Nemesis Delay User's Guide
. The C L will now be lit solid red.
ONTROL ED
L should be off. Then, press and hold the C
ED
I and set the P
EDAL N EDAL
1/4"
Switch Out
until the C L
ONTROL ED
I
ONTROL NPUT
ONTROL
I S to the E
N WITCH XP
L should be lit red.
ONTROL ED
begins to blink slowly
31