Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for Source Audio Soundblox Pro
Summary of Contents for Source Audio Soundblox Pro
- Page 1 MULTIWAVE BASS DISTORTION USERS GUIDE SA141...
- Page 2 MIDI Enjoy! MOTION CONTROL The Source Audio team All Soundblox and Soundblox Pro pedals are “Hot Hand Ready” and can be used with any Hot Hand motion sensor to extend the capabilities of the unit. ACTIVE ANALOG BYPASS Bypass is fully routed around the and active input ensures zero signal degradation.
-
Page 3: Quick Start
QUICK START 3. BRIEF KNOB, FOOTSWITCH, AND BUTTON DESCRIPTIONS See Controls section for more details. adjusts how much equalizer is applied to the signal. A EQ AMOUNT: 1. POWER the amount of distortion gain applied to the signal. B DRIVE: To power the unit, connect the included adapter power supply to select preset bank A (presets , and... -
Page 4: Theory Of Operation
(or clips) at a maximum value. With a foldback curve, for large enough values of the input, the The Soundblox Pro Multiwave Bass Distortion provides some unique output will begin to decrease. With more extreme amounts of foldback, distortion sounds. - Page 5 FOLDBACK Connect an optional Hot Hand sensor here, either wired or wireless. FOLDBACK SENSOR OUT (optional) SINGLE BAND Use a Source Audio daisy-chain cable to connect this jack to the sensor NORMAL input of another pedal. OCTAVE MIDI IN (optional) CLEAN BOOST / EQ program and continuous control input.
- Page 6 CONTROLS: EQUALIZER DRIVE control adjusts the gain of the signal going into the distortion DRIVE section. The higher the , the more distorted the signal. DRIVE One of the key features of the Pro is the -band graphic equalizer. The Equalizer is post distortion. Each band can be adjusted up or down steps from and the setting is indicated by the dis- 1 dB...
- Page 7 CONTROLS: OTHER BUTTONS CONTROLS: FOOTSWITCHES PRESET BANK There are three footswitches on the Pro. From left to right, the There are six available user presets that are in two banks. The bank can footswitches correspond to presets , and for preset bank A and be switched by pressing the button.
-
Page 8: Effect Types
EFFECT TYPES MULTI BAND NORMAL 0-3 Here are some brief descriptions of the effects included in the Pro. These four settings are best for maximum clarity of the individual notes knob settings are split into two major categories: EFFECT MULTI in a chord. - Page 9 PRESET SAVING MORPHING An edited preset can be saved by pressing and holding a footswitch as The expression input on the MWB Pro can be used to morph between described in the Controls: Footswitches section. An edited preset can be two presets.
-
Page 10: Midi Control
Pro. Addition- Program Change messages. The Pro can also be put into by- MIDI ally, the jack will be compatible with any future Source Audio SENSOR IN pass in this way. The following table describes the use of the input. MIDI sensors. - Page 11 BACKPAGE PARAMETERS HH Enable button will allow Hot Hand control for an individual HH ENABLE ® preset so it can be used on one preset and not on another. Pro has some additional controls that can only be edited Calibration in a special mode called Backpage mode.
-
Page 12: Specifications
SPECIFICATIONS Here is the list of parameters that can be edited in Backpage mode: Noise Gate (NG) This sets the threshold of the noise gate. Lower values lower the thresh- Dimensions Power old, and result in less gating action. The default value is set to what L: 7 inches (18.1cm) 110mA @ 9 VDC (max 145mA w/ Hot Hand •... -
Page 13: Limited Warranty
THE FOREGOING LIMITED WARRANTY IS THE ONLY WARRANTY ranted for the remainder of the original warranty period. GIVEN BY SOURCE AUDIO AND IS IN LIEU OF ALL OTHER WAR- RANTIES. ALL IMPLIED WARRANTIES, INCLUDING WARRANTIES This Limited Warranty is extended to the original retail OF MERCHANTABILITY AND FITNESS FOR ANY PARTICULAR purchaser.