Source Audio Nemesis Delay User Manual page 32

3. Tap the external switch once.
4. Click the O /O
N
second). Now, it is time to map the external switch to the effect parameters.
5. Move the knob(s) you wish to control with the external switch to the maximum desired
position, then click the O
(about 4 blinks per second). Note that you may control one or more knobs with the external
switch, up to six total knobs.
6. Move the knob(s) you wish to control with the expression pedal to the minimum desired
position, then click the O
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Expression Toggle Connected to Control Input
To use this mode, connect an external switch to C
S position instead of the E
WITCH
Ground
Follow these steps for configuration:
1. Press the C
ONTROL
2. Press and hold the C
(approximately one blink per second).
3. Tap the external switch once.
4. Click the O /O
N
second). Now, it is time to map the external switch to the effect parameters.
5. Move the knob(s) you wish to control with the external switch to the maximum desired
position, then click the O
(about 4 blinks per second). Note that you may control one or more knobs with the external
switch, up to six total knobs.
6. Move the knob(s) you wish to control with the expression pedal to the minimum desired
position, then click the O
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Hot Hand Input
The Hot Hand 3 Wireless Effects Controller can be connected directly to the C
wireless motion control of the Nemesis's effects parameters. The Hot Hand has two axes of
SA260
F once. The C
FF OOTSWITCH
/O F
N FF OOTSWITCH
/O F
N FF OOTSWITCH
position. The following plug configuration is required:
XP
Switch Out
I B to enable external control. The C
NPUT UTTON
I B
ONTROL NPUT UTTON
F once. The C
FF OOTSWITCH
/O F
N FF OOTSWITCH
/O F
N FF OOTSWITCH
Nemesis Delay User's Guide
L will blink faster (about 2 blinks per
ONTROL ED
. The C L will now blink even faster
ONTROL ED
. The C L will now be lit solid red.
ONTROL ED
I and set the P
ONTROL NPUT
1/8" (3.5mm)
Power (Switch pull-up)
until the C L begins to blink slowly
ONTROL ED
L will blink faster (about 2 blinks per
ONTROL ED
. The C L will now blink even faster
ONTROL ED
. The C L will now be lit solid red.
ONTROL ED
I S to the
EDAL N WITCH
L should be lit red.
ONTROL ED
I jack for
ONTROL NPUT
32