Mitsubishi Mirage 2017 Owner's Manual page 93

Power window control
stopped. However, once the driver's door or
the front passenger's door is opened, the
power windows cannot be operated.
Lock switch
When this switch is in the lock mode, the pas-
5
senger door switches cannot be used to open
or close the door windows, and the main
switch will open or close only the driver's
door window. To unlock the switch, press it
again.
Type 1
Type 2
1- Lock
2- Unlock
5-30 Features and controls
WARNING
 Before driving with a child in the vehicle,
be sure to lock the window switch to make
it inoperative. Children tampering with
the switch could easily trap their hands or
heads in the window.
N00549000169
Safety mechanism (Driver's
door window of Type 1 only)
If a hand or head is trapped, for safety the
door window is automatically lowered a little.
After the door window is lowered, clear the
obstruction, then pull up the switch again to
close the door window.
WARNING
 If the battery terminals are disconnected
or the fuse for electric window is replaced,
the safety mechanism will be cancelled.
If a hand or head got trapped, a serious
injury could result.
CAUTION
 The safety mechanism is deactivated just
before the door window closes. This allows
the door window to close completely. There-
fore be especially careful that fingers are not
trapped in the door window opening.
CAUTION
 The safety mechanism is deactivated while
the switch is pulled up. Therefore be espe-
cially careful that fingers are not trapped in
the door window opening.
 Do not deliberately trap your hands or head
in order to activate the safety mechanism.
Your hand or head could be trapped and per-
sonal injury could result.
NOTE
N00528801158
 The safety mechanism can be activated if the
driving conditions or other circumstances
cause the door window to be subjected to a
physical shock similar to that caused by
trapped hand or head.
 If the safety mechanism is activated 5 or
more times in a row, the safety mechanism
will be cancelled and the door window will
not close correctly. In such a case, the fol-
lowing procedure should be implemented to
rectify this situation. If the window is open,
repeatedly raise the driver's door window
switch until that window has been fully
closed.
Following this, release the switch, raise the
switch once again and hold it in this condi-
tion for at least 1 second, then release it. You
should now be able to operate in the normal
fashion.