Manual Transaxle (If So Equipped) - Mitsubishi Mirage 2017 Owner's Manual

NOTE
 On vehicles equipped with CVT, the starter
will not operate unless the selector lever is in
the "P" (PARK) or "N" (NEUTRAL) posi-
tion.
For safety reasons, start the engine in the "P"
(PARK) position so that the wheels are
locked.
7. Turn the ignition switch to the "ON" posi-
tion and make certain that all warning
lights are functioning properly before
starting the engine.
8. Turn the ignition switch to the "START"
position without pressing the accelerator
pedal. Release the key when the engine
starts.
NOTE
 Minor noises may be heard on engine start-
up. These will disappear as the engine warms
up.
When the engine is hard to start
After several attempts, you may experience
that the engine still does not start.
1. Make sure that all electric devices, such
as lights, air conditioning blower and rear
window defogger, are turned off.
2. While depressing the brake pedal {contin-
uously variable transmission (CVT)} or
the clutch pedal (manual transaxle), press
the accelerator pedal halfway and hold it
there, then crank the engine. Release the
accelerator pedal, immediately after the
engine starts.
3. If the engine still will not start, the engine
could be flooded with too much gasoline.
While depressing the brake pedal (CVT)
or the clutch pedal (manual transaxle),
push the accelerator pedal all the way
down and hold it there, then crank the
engine for 5 to 6 seconds. Return the igni-
tion switch to the "OFF" position and
release the accelerator pedal. Wait a few
seconds, and then crank the engine again
for 5 to 6 seconds while depressing the
brake pedal (CVT) or the clutch pedal
(manual transaxle), but do not push the
accelerator pedal. Release the ignition key
if the engine starts. If the engine fails to
start, repeat these procedures. If the
engine still will not start, contact your
local Mitsubishi Motors dealer or a repair
facility of your choice for assistance.

Manual transaxle (if so equipped)

Startability of CVT vehicle with
ambient temperature of -4 °F (-20
°C) or lower
When the ambient temperature is -4 °F (-20
°C) or lower, it may not be possible to start
from a standstill even with the selector lever
in the "D" (DRIVE) or "R" (REVERSE)
position.
This phenomenon occurs because the trans-
axle has not warmed up sufficiently; it does
not indicate a problem. If this occurs, place
the selector lever in the "P" (PARK) position
and let the engine idle for at least 10 minutes.
The transaxle will warm up, and you will be
able to start normally.
Do not leave the vehicle during warm-up
operation.
Manual transaxle
(if so
equipped)
The shift pattern below is shown on the gear-
shift lever. Press the clutch pedal all the way
down while shifting gears.
Features and controls
5
N00512701181
5-37