Mitsubishi Mirage 2017 Owner's Manual page 207

AM/FM electronically tuned radio with CD player (if so equipped)
Volume and tone control panel
7
1- PWR (On-Off)/VOL (Volume con-
trol)/SEL (Select) switch
2- Display
3-
/MENU (Mode change) button
4- SEL (Select) indicator
5-
(Return) button
To adjust the volume
Turn the VOL switch clockwise to increase
the volume; counterclockwise to decrease the
volume.
The status will be displayed in the display.
7-20 Comfort controls
To adjust the tone
N00711901742
1. Press the /MENU button to select
BASS  TREBLE  FADER  BAL-
ANCE  Sound control mode off.
2. Turn the SEL switch either clockwise or
counterclockwise to change the tone/bal-
ance setting.
The status will be displayed in the display.
BASS (Bass tone control)
To select the desired bass level.
TREBLE (Treble tone control)
To select the desired treble level.
FADER (Front/Rear balance con-
trol)
N00712001421
To balance the volume from the F (front) and
the R (rear) speakers.
BALANCE (Left/Right balance
control)
To balance the volume from the L (left) and
the R (right) speakers.
NOTE
 When operation of turn of the SEL switch is
N00712101709
enabled, the SEL indicator will appear on the
display.
 When set to "0", it will beep.
 When the following operation is performed,
this mode will be canceled.
• The button is pressed.
• The another mode is selected.
• The any adjustment is not performed for
more than 10 seconds.
 In a two-speakers vehicle, keep the FADER
setting in the middle position. Since no rear
speakers are connected,
FADER setting toward the "R" (rear) side
will result in a loss of sound output.
Radio control panel and display
1- RADIO (AM/FM selection) button
adjusting the
N00734901925