Mitsubishi Mirage 2017 Owner's Manual page 148

Security function
It is possible to use a passcode as a security
function by setting a passcode of your choice
®
for the Bluetooth 2.0 interface.
When the security function is turned on, it is
necessary to make a voice input of a 4-digit
passcode in order to use all functions of the
®
Bluetooth 2.0 interface, except for recep-
tion.
Setting the passcode
Use the following procedure to turn on the
security function by setting a passcode.
1. Press the SPEECH button.
2. Say "Setup."
3. Say "Passcode."
4. The voice guide will say "Passcode is dis-
abled. Would you like to enable it?"
Answer "Yes."
Answer "No" to cancel the setting of the
passcode and return to the main menu.
5. The voice guide will say "Please say a 4-
digit passcode. Remember this passcode.
It will be required to use this system."
Say a 4-digit number which you want to
set as a passcode.
6. For confirmation purposes, the voice
guide will say "Passcode <4-digit pass-
code>. Is this correct?" Answer "Yes."
Answer "No" to return to the passcode
input in Step 5.
N00564600023
7. When the registration of the passcode is
completed, the voice guide will say "Pass-
code is enabled" and the system will
return to the main menu.
NOTE
 Passcode will be required to access the sys-
tem after the next ignition cycle.
 It is required for a little time after engine
stop that the entered passcode is actually
recorded in the system.
If the ignition switch or the operation mode
is made to ACC or ON or the engine is
started immediately after engine stop, there
is a case when the entered passcode is not
recorded in the system. At this time, please
try to enter the passcode again.
Entering the passcode
If a passcode has been set and the security
function is enabled, the voice guide will say
"Hands-free system is locked. State the pass-
code to continue" when the SPEECH button
is pressed to enter voice recognition mode.
Say the 4-digit passcode number to enter the
passcode.
If the entered passcode is wrong, the voice
guide will say "<4-digit passcode>, Incorrect
passcode. Please try again." Enter the correct
passcode.
Bluetooth® 2.0 interface (if so equipped)
NOTE
 You can reenter the passcode as many times
as you want.
 If you have forgotten your passcode, say
"Cancel" to quit the voice input mode and
then check with an authorized Mitsubishi
Motors dealer.
Disabling the passcode
Use the following procedure to turn off the
security function by disabling the passcode.
NOTE
 System must be unlocked to disable the pass-
code.
1. Press the SPEECH button.
2. Say "Setup."
3. Say "Passcode."
4. The voice guide will say "Passcode is
enabled. Would you like to disable it?"
Answer "Yes."
Answer "No" to cancel the disabling of
the passcode and return to the main menu.
5. When the disabling of the passcode is
completed, the voice guide will say "Pass-
code is disabled" and the system will
return to the main menu.
Features and controls
5
5-85