GE D60 Instruction Manual page 22

1.3 ENERVISTA UR SETUP SOFTWARE
5. Enter an IP address with the first three numbers the same as the IP address of the D60 relay and the last number dif-
1
ferent (in this example, 1.1.1.2).
6. Enter a subnet mask equal to the one set in the D60 (in this example, 255.0.0.0).
7. Click the OK button to save the values.
Before continuing, test the Ethernet connection.
1. Open a Windows console window by selecting Start > Run from the Windows Start menu and typing "cmd".
2. Type the following command, substituting the IP address of 1.1.1.1 with yours:
C:\WINNT>ping 1.1.1.1
3. If the connection is successful, the system returns four replies similar to the following:
Pinging 1.1.1.1 with 32 bytes of data:
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Ping statistics for 1.1.1.1:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip time in milliseconds:
Minimum = 0ms, Maximum = 0ms, Average = 0 ms
4. Note that the values for
5. If the following sequence of messages appears when entering the
Pinging 1.1.1.1 with 32 bytes of data:
Request timed out.
Request timed out.
Request timed out.
Request timed out.
Ping statistics for 1.1.1.1:
Packets: Sent = 4, Received = 0, Lost = 4 (100% loss),
Approximate round trip time in milliseconds:
Minimum = 0ms, Maximum = 0ms, Average = 0 ms
Pinging 1.1.1.1 with 32 bytes of data:
verify the physical connection between the D60 and the laptop computer, and double-check the programmed IP
address in the
PRODUCT SETUP
6. If the following sequence of messages appears when entering the
Pinging 1.1.1.1 with 32 bytes of data:
Hardware error.
Hardware error.
Hardware error.
Hardware error.
Ping statistics for 1.1.1.1:
Packets: Sent = 4, Received = 0, Lost = 4 (100% loss),
Approximate round trip time in milliseconds:
Minimum = 0ms, Maximum = 0ms, Average = 0 ms
Pinging 1.1.1.1 with 32 bytes of data:
verify the physical connection between the D60 and the laptop computer, and double-check the programmed IP
address in the
PRODUCT SETUP
7. If the following sequence of messages appears when entering the
1-12
and vary depending on local network configuration.
time TTL

COMMUNICATIONS

COMMUNICATIONS
D60 Line Distance Protection System
C:\WINNT>ping 1.1.1.1
 
NETWORK IP ADDRESS
C:\WINNT>ping 1.1.1.1
 
NETWORK IP ADDRESS
C:\WINNT>ping 1.1.1.1
1 GETTING STARTED
command:
setting, then repeat step 2.
command:
setting, then repeat step 2.
command:
GE Multilin