B.r.a - GRAUPNER X-8E Manual

NORMAL
BACK
CH THROTTLE
FWD
Curve
TH.hold
OFF
Curve
POINT ? 0%
ST OFF
X-axis
Y-axis
+/-
BACK
NORMAL
CH THROTTLE
BRK
D/R +100%
EXP 0%
B.R.A. (ATL)
NORMAL
BACK
RATE F50:B50

B.R.A

100%
0%
BK
S1008_X-8E_jh_V1
THROTTLE FWD point setting step by step:
SERVO
1. Press the "ST OFF" button to switch to "ST ON".
TYPE
2. Move the throttle lever.
3. A green line moves horizontally through the diagram.
4. Press the +/- key to create a new point. Multiple points
can be set by pressing the arrow key.
ON
5. Delete highlighted points by pressing the +/- key.
THROTTLE FWD point moving step by step:
1. Press the "ST ON" button to switch to "ST OFF".
2. Press the <+ or -> keys to scroll through the points. Points
will highlight red when selected. Delete highlighted points
by pressing the +/- key.
3. Select the X-axis or the Y-axis button. Press the <+ or
-> keys to change axis curve or to reposition points along
the axis.
TH.hold
Use this option while programming a curve prevent the motor
from running. Tap the ON and OFF button to switch the throttle
channel on and off.
Brake force setting
SERVO
1. Select the "THROTTLE" setting by pressing the "STEER-
ING" button.
2. Select the "BRK" setting by tipping on the "FWD" button.
3. Moving the throttle lever. The green axis line moves in the
diaplay.
4. To adjust the force setting, select the percent button near
"D/R" or "EXP". Press the <+ or -> keys to raise or lower
value. Press the curved arrow key to reset the default
value.
Break rate and travel setting menu.
SERVO
RATE: Factory default setting is F50:B:50. Press the button in
the RATE line to switch to F70:B:30 and move the servo center.
B.R.A: To adjust the travel, highlight the percent button in the
B.R.A. line. Press the <+ or -> keys to raise or lower value.
Press the curved arrow key to reset to the default value (100%).
FW
29 / 48