Rear Fan - HP Compaq 6005 Pro Maintenance And Service Manual

Rear Fan

The rear fan is secured to the rear right corner of the chassis. You must remove the system board
before you can remove the rear fan.
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the front bezel
4. Remove the optical drive
5. Remove the memory modules
6. Remove the hard drive
7. Remove the hard drive cage
8. Remove the front fan
9. Remove the heat sink
10. Remove the system board
11. Disconnect the fan control cable from the maroon system board connector labeled
CHFAN_REAR.
12. From the outside of the chassis, remove the four Phillips screws that secure the fan to the
chassis (1), then from the inside of the chassis, slide the fan forward and lift it up and out of the
chassis (2).
Figure 6-39
To install the rear fan, reverse the removal procedure.
(Front Bezel on page
(Removing the Existing Optical Drive on page
(Installing Additional Memory on page
(Hard Drive on page
(Hard Drive Cage on page
(Front Fan on page
(Heat sink on page
(System Board on page
Removing the rear fan
(Preparation for Disassembly on page
(Computer Access Panel on page
41).
51).
55).
56).
60).
64).
31).
40).
48).
43).
Rear Fan
67