System Board - HP Compaq 6005 Pro Maintenance And Service Manual

5. If using a new heat sink, remove the protective covering from the bottom of the heat sink and
place it in position atop the processor.
6. Secure the heat sink to the system board, and then attach the heat sink control cable to the
system board if applicable.
CAUTION:
pairs (as in an X) to evenly seat the heat sink on the processor. This is especially important as
the pins on the socket are very fragile and any damage to them may require replacing the

system board.

NOTE: After installing a new processor onto the system board, always update the system ROM to
ensure that the latest version of the BIOS is being used on the computer. The latest system BIOS can
be found on the Web at: http://h18000.www1.hp.com/support/files.
System Board
CAUTION:
it.
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the front bezel
4. Remove the optical drive
5. Remove the memory modules
6. Remove the hard drive
7. Remove the hard drive cage
8. Remove the front fan
9. Remove the heat sink
10. Remove the front I/O panel cage:
a. Remove the Torx T15 screw from the right side of the cage that secures the I/O panel cage
to the front of the chassis (1).
64 Chapter 6 Removal and Replacement Procedures
If applicable, heat sink retaining screws should be tightened in diagonally opposite
Be very careful when removing or replacing the system board to prevent damaging
(Front Bezel on page
(Removing the Existing Optical Drive on page
(Installing Additional Memory on page
(Hard Drive on page
(Hard Drive Cage on page
(Front Fan on page
(Heat sink on page
(Preparation for Disassembly on page
(Computer Access Panel on page
41).
51).
55).
56).
60).
31).
40).
48).
43).