Speaker
The speaker is secured to the front of the chassis between the fan and the I/O ports.
1.
Prepare the computer for disassembly
2.
Remove the computer access panel
3.
Remove the front bezel
4.
Disconnect the speaker cable from the white system board connector labeled SPKR.
5.
From the outside of the chassis, remove the two Torx T8 screws that secure the speaker to the
chassis (1), and then from the inside of the chassis, slide the speaker up and lift it out (2).
Figure 6-33
To install the speaker, reverse the removal procedure.
(Front Bezel on page
Removing the speaker
(Preparation for Disassembly on page
(Computer Access Panel on page
41).
31).
40).
Speaker
59