HP Compaq 6005 Pro Maintenance And Service Manual page 28

Table 3-6 Computer Setup—Advanced (for advanced users) (continued)
Option
Execute Memory Test
(some models)
18 Chapter 3 Computer Setup (F10) Utility
Description
◦ Clear Memory = No memory count on cold boot. Clears memory on all boots.
◦
FullBoot Every x Days = Memory count on 1st cold boot on or after the xth day. No
more memory counts until 1st cold boot on or after x days. Clears memory on all boots.
●
POST messages (enable/disable).
●
F9 prompt (enable/disable or hidden/displayed). Enabling this feature will display the text F9
= Boot Menu during POST. Disabling this feature prevents the text from being displayed.
However, pressing F9 will still access the Shortcut Boot [Order] Menu screen. See Storage >
Boot Order for more information.
●
F10 prompt (enable/disable or hidden/displayed). Enabling this feature will display the text
F10 = Setup during POST. Disabling this feature prevents the text from being displayed.
However, pressing F10
●
F11 prompt (hidden/displayed). Setting this feature to displayed will display the text
F11 = Recovery during POST. Hiding this feature prevents the text from being displayed.
However, pressing F11
Recovery Boot Support for more information.
●
F12 prompt (enable/disable or hidden/displayed). Enabling this feature will display the text
F12 = Network during POST. Disabling this feature prevents the text from being displayed.
However, pressing F12
●
Factory Recovery Boot Support (enable/disable). Enabling this feature will cause an
additional prompt, F11 = Recovery, to be displayed during POST on systems with a
recovery partition on the boot hard drive. Pressing
recovery partition. The F11 = Recovery prompt can be hidden with the
displayed) option (see above).
●
Option ROM prompt (enable/disable) Enabling this feature will cause the system to display a
message before loading option ROMs. (This feature is supported on some models only.)
●
Remote wakeup boot source (remote server/local hard drive).
●
After Power Loss (off/on/previous state): Setting this option to:
◦
Off—causes the computer to remain powered off when power is restored.
◦ On—causes the computer to power on automatically as soon as power is restored.
◦
Previous state—causes the computer to power on automatically as soon as power is
restored, if it was on when power was lost.
NOTE: If you turn off power to the computer using the switch on a power strip, you will not be
able to use the suspend/sleep feature or the Remote Management features.
●
POST Delay (None, 5, 10 15, or 20 seconds). Enabling this feature will add a user-specified
delay to the POST process. This delay is sometimes needed for hard disks on some PCI
cards that spin up very slowly, so slowly that they are not ready to boot by the time POST is
finished. The POST delay also gives you more time to select
Setup.
●
Bypass F1 Prompt. This feature allows the system to boot without pressing
when the configuration changes.
Restarts the computer and executes the POST memory test.
will still access the Setup screen.
will still attempt to boot to the recovery partition. See Factory
will still force the system to attempt booting from the network.
F11 causes the system to boot to the
F11 prompt (hidden/
F10 to enter Computer (F10)
F1 at the prompt