Hard Drive Cage
The drive cage sits behind the USB ports on the front of the chassis.
1.
Prepare the computer for disassembly
2.
Remove the computer access panel
3.
Remove the optical drive and connector
4.
Remove the hard drive
5.
Remove the two Torx T15 screws that secure the cage to the chassis (1), lift the tab (2) on the
hard drive cage, slide the cage toward the rear of the unit, and then pull the cage up and out of
the chassis (3).
Figure 6-29
To install the hard drive cage, reverse the removal procedures.
(Hard Drive on page
Removing the hard drive cage
(Preparation for Disassembly on page
(Computer Access Panel on page
(Removing the Existing Optical Drive on page
51).
31).
40).
48).
Hard Drive Cage
55