Adjusting The Feed Dogs & Stitch Length; Feed Dog Height; Stitch Length; Differential Feed Ratio - KANSAI SPECIAL V Series Instructions Manual

【7】ADJUSTING THE FEED DOGS & STITCH LENGTH

7 7 7 7 - - - - 1 Feed dog height

1 Feed dog height
1 Feed dog height 1 Feed dog height
When the feed dogs are at the top of their stroke, the
feed dog teeth should be 0.8~1.2mm above the top
surface of the needle plate.
Adjustment is made by loosening screws A and B.

7 7 7 7 - - - - 2 Stitch length

2 Stitch length 2 Stitch length 2 Stitch length
Loosen bolt A with a 9.5mm T wrench and turn screw
B as required. To increase the stitch length, turn
screw B counterclockwise.
To decrease the stitch length, turn screw B clockwise.

7 7 7 7 - - - - 3 Differential feed ratio

3 Differential feed ratio 3 Differential feed ratio 3 Differential feed ratio
Remove rubber plug C. Loosen nut D.
To increase the differential feed ratio, move nut D
up.
To decrease the differential feed ratio, move nut D
down.
10