Position Of The Looper Thread Take-Up; Emk Elastic Feeder; To Insert The Lace/Elastic; Lace/Elastic Guide On The Presser Foot - KANSAI SPECIAL WX Series Instruction Manual

10- - - - 7 Position of the looper thread take 10 10 10 7 Position of the looper thread take 7 Position of the looper thread take 7 Position of the looper thread take- - - - up
Thread guide D should be at the center of the groove of
looper thread take-up A.
needle has reached 0.5~1mm above the bottom surface of
the looper blade while the looper is moving from the
extreme left end of its travel, the looper thread should be
removed from position C on the looper thread take-up.
To make this adjustment, loosen screw B and adjust the
looper thread take-up.
guide D, loosen screw E and then align the bottom of the
slot of thread guide D with the top surface of the bracket.
【11】EMK ELASTIC FEEDER
11 11 11

11- - - - 1 To insert the lace/elastic

1 To insert the lace/elastic 1 To insert the lace/elastic 1 To insert the lace/elastic
Insert the lace/elastic correctly by referring to the
illustration. The rollers are opened by pressing rubber
adjusting lever A.
11

11- - - - 2 Lace/elastic guide on the presser foot

11 11 2 Lace/elastic guide on the presser foot 2 Lace/elastic guide on the presser foot 2 Lace/elastic guide on the presser foot
Loosen screw A. Adjust the position of the tape guide
according to the needle space and/or width of the tape.
Adjust the position of upper knife guide B according to the
hem width cut by the knife. Install upper knife guide B
by tightening screw C while checking upper knife guide B
does not touch the knife.

11- - - - 3 Adjusting the front of the presser foot

11 3 Adjusting the front of the presser foot
11 11 3 Adjusting the front of the presser foot 3 Adjusting the front of the presser foot
Adjust the front of the presser foot according to the type of
fabric and/or elastic to be used.
To sew heavy weight elastic onto the fabric, raise the front
of the presser foot. This reduces resistance and feeds the
fabric smoothly.
required.
up up up
When the point of the left
To adjust the height of thread
Loosen nut D and turn screw E as
16