Configuring Pim-Ssm; Pim-Ssm Configuration Task List; Configuration Prerequisites; Enabling Pim-Sm - HP MSR1002-4 Configuration Manual

Step
1. Enter system view.
2. Enter PIM view.
3. Disable the device from
sending
incoming interfaces.

Configuring PIM-SSM

PIM-SSM requires IGMPv3 support. Enable IGMPv3 on PIM routers that connect to multicast
receivers.

PIM-SSM configuration task list

Tasks at a glance
(Required.)
(Optional.)
(Optional.)

Configuration prerequisites

Before you configure PIM-SSM, configure a unicast routing protocol so that all devices in the domain
can interoperate at the network layer.

Enabling PIM-SM

Before you configure PIM-SSM, you must enable PIM-SM, because the implementation of the SSM
model is based on subsets of PIM-SM.
When you deploy a PIM-SSM domain, enable PIM-SM on non-border interfaces of the routers.
IMPORTANT:
All the interfaces on a device must be enabled with the same PIM mode.
To enable PIM-SM:
Step
1. Enter system view.
2. Enable IP multicast routing,
and enter MRIB view.
3. Return to system view.
4. Enter interface view.
5. Enable PIM-SM.
BSMs out of
Enabling PIM-SM
Configuring the SSM group range
Configuring common PIM features
Command
system-view
pim [ vpn-instance
vpn-instance-name ]
undo bsm-reflection enable
Command
system-view
multicast
[ vpn-instance
vpn-instance-name ]
quit
interface interface-type
interface-number
pim sm
117
Remarks
N/A
N/A
By default, the device is enabled
to forward BSMs out of incoming
interfaces.
Remarks
N/A
routing
By default, IP multicast routing is
disabled.
N/A
N/A
By default, PIM-SM is disabled.