Specifying The Longest Prefix Match Principle; Configuring Multicast Load Splitting; Configuring A Multicast Forwarding Boundary - HP MSR1002-4 Configuration Manual

Step
3. (Optional.) Delete static
multicast routes.

Specifying the longest prefix match principle

You can enable the device to use the longest prefix match principle for RPF route selection. For more
information about RPF route selection, see
To specify the longest prefix match principle:
Step
1. Enter system view.
2. Enter MRIB view.
3. Specify the longest prefix
match principle.

Configuring multicast load splitting

You can enable the device to split multiple data flows on a per-source basis or on a
per-source-and-group basis. This optimizes the traffic delivery.
To configure multicast load splitting:
Step
1. Enter system view.
2. Enter MRIB view.
3. Configure
splitting.

Configuring a multicast forwarding boundary

You can configure an interface as a multicast forwarding boundary for a multicast group range. The
interface cannot receive or forward multicast packets for the group range.
Command
•
Delete a specific static multicast
route:
undo
[
vpn-instance-name
source-address { mask-length |
mask
interface-type interface-number }
•
Delete all static multicast routes:
delete
[
vpn-instance-name ]
Command
system-view
multicast
[
vpn-instance-name ]
longest-match
Command
system-view
multicast
[
vpn-instance-name ]
multicast load
load-splitting
source-group }
ip rpf-route-static
vpn-instance
} { rpf-nbr-address
ip rpf-route-static
vpn-instance
"RPF check process."
routing
vpn-instance
routing
vpn-instance
{ source |
47
Remarks
]
N/A
|
Remarks
N/A
N/A
By default, the route preference
principle is used.
Remarks
N/A
N/A
By default, multicast load splitting
is disabled.
This command does not take
effect on BIDIR-PIM.