Multicast Forwarding Across Unicast Subnets - HP MSR1002-4 Configuration Manual

Figure 17 Creating an RPF route
Multicast Routing Table Static on Router C
Source/Mask
192.168.0.0/24
Multicast Routing Table Static on Router D
Source/Mask
192.168.0.0/24
Source
192.168.0.1/24
Multicast packets
As shown in
For the receiver hosts in the OSPF domain to receive multicast packets from the multicast source in
the RIP domain, you must configure Router C and Router D as follows:
•
On Router C, configure a static multicast route for the multicast source and specify Router B as
the RPF neighbor.
•
On Router D, configure a static multicast route for the multicast source and specify Router C as
the RPF neighbor.
NOTE:
A static multicast route is effective only on the multicast router on which it is configured, and will not
be advertised throughout the network or redistributed to other routers.

Multicast forwarding across unicast subnets

Routers forward the multicast data from a multicast source hop by hop along the forwarding tree, but
some routers might not support multicast protocols in a network. When the multicast data is
forwarded to a router that does not support IP multicast, the forwarding path is blocked. In this case,
you can enable multicast forwarding across two unicast subnets by establishing a tunnel between
the routers at the edges of the two unicast subnets.
Interface RPF neighbor/Mask
GE1/0/1 1.1.1.1/24
Interface RPF neighbor/Mask
GE1/0/1 2.2.2.2/24
RIP domain
Router A Router B
Figure 17, the RIP domain and the OSPF domain are unicast isolated from each other.
OSPF domain
Router D
GE1/0/2 GE1/0/1
1.1.1.1/24 1.1.1.2/24
Router C
Multicast static route
44
Receiver
GE1/0/1
2.2.2.1/24
GE1/0/2
Receiver
2.2.2.2/24