Enabling Snmp Notifications For Vrrp; Disabling An Ipv4 Vrrp Group; Displaying And Maintaining Ipv4 Vrrp - HP VSR1000 High Availability Configuration Manual

Step
3. Configure the VFs in a VRRP
group to monitor a track entry
and configure the reduced
weight.

Enabling SNMP notifications for VRRP

Perform this task to enable VRRP to report important events through notifications to the SNMP module.
The SNMP module determines how to output the notifications according to the configured output rules.
For more information about notifications, see Network Management and Monitoring Configuration
Guide.
To enable SNMP notifications for VRRP:
Step
1. Enter system view.
2. Enable SNMP notifications for
VRRP.

Disabling an IPv4 VRRP group

You can temporarily disable an IPv4 VRRP group. After being disabled, the VRRP group stays in
initialized state, and its configurations remain unchanged. You can change the configuration of a VRRP
group when the VRRP group is disabled. Your changes take effect when you enable the VRRP group
again.
To disable an IPv4 VRRP group:
Step
1. Enter system view.
2. Enter interface view.
3. Disable a VRRP group.

Displaying and maintaining IPv4 VRRP

Execute display commands in any view and the reset command in user view.
Task
Display states of IPv4 VRRP groups.
Display statistics for IPv4 VRRP
groups.
Command
vrrp vrid virtual-router-id weight
track track-entry-number [ reduced
weight-reduced ]
Command
system-view
snmp-agent trap enable vrrp
[ auth-failure | new-master ]
Command
system-view
interface interface-type
interface-number
vrrp vrid virtual-router-id shutdown
Command
display vrrp [ interface interface-type interface-number [ vrid
virtual-router-id ] ] [ verbose ]
display vrrp statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
15
Remarks
By default, no track entry is
specified.
Remarks
N/A
By default, SNMP notifications for
VRRP are enabled.
Remarks
N/A
N/A
By default, a VRRP group is
enabled.