Igmp Configuration Task List; Configuring Basic Igmp Features; Enabling Igmp - HP MSR1002-4 Configuration Manual

IGMP configuration task list

Tasks at a glance
Configuring basic IGMP
•
(Required.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
Adjusting IGMP
(Optional.)
(Optional.)
(Optional.)
Configuring IGMP
•
(Optional.)
•
(Optional.)
•
(Optional.)
(Optional.)

Configuring basic IGMP features

Before you configure basic IGMP features, complete the following tasks:
•
Configure any unicast routing protocol so that all devices can interoperate at the network layer.
•
Configure PIM.
•
Determine the IGMP version.
•
Determine the multicast group and multicast source addresses for static group member
configuration.
•
Determine the ACL to be used in the multicast group policy.

Enabling IGMP

Enable IGMP on the interface where the multicast group memberships are established and
maintained.
To enable IGMP:
Step
1. Enter system view.
2. Enable IP multicast routing
and enter MRIB view.
3. Return to system view.
4. Enter interface view.
5. Enable IGMP.
features:
Enabling IGMP
Specifying an IGMP version
Configuring a static group member
Configuring a multicast group policy
performance:
Configuring IGMP query and response parameters
Enabling fast-leave processing
Configuring IGMP SSM mappings
proxying:
Enabling IGMP proxying
Enabling multicast forwarding on a non-querier interface
Configuring multicast load splitting on an IGMP proxy
Enabling IGMP NSR
Command
system-view
multicast
[ vpn-instance
vpn-instance-name ]
quit
interface
interface-type
interface-number
igmp enable
71
Remarks
N/A
routing
By default, IP multicast routing is
disabled.
N/A
N/A
By default, IGMP is disabled.