Setting The Maximum Size Of Each Join Or Prune Message - HP MSR1002-4 Configuration Manual

Step
2. Enter IPv6 PIM view.
3. Set the hello interval.
4. Set the join/prune interval.
5. Set the joined/pruned state
holdtime.
6. Set the
source lifetime.
Configuring common IPv6 PIM timers on an interface
Step
1. Enter system view.
2. Enter interface view.
3. Set the hello interval.
4. Set the triggered hello delay.
5. Set the join/prune interval.
6. Set the joined/pruned state
holdtime.

Setting the maximum size of each join or prune message

The loss of an oversized join or prune message might result in loss of massive information. You can
set a small value for the size of each join or prune message to reduce the impact.
To set the maximum size of each join or prune message:
Step
1. Enter system view.
2. Enter IPv6 PIM view.
3. Set the maximum size of
each join or prune message.
Command
ipv6
vpn-instance-name ]
timer hello interval
timer join-prune interval
holdtime join-prune time
IPv6 multicast
source-lifetime time
Command
system-view
interface
interface-number
ipv6 pim timer hello interval
ipv6 pim triggered-hello-delay
delay
ipv6
interval
ipv6 pim holdtime join-prune
time
Command
system-view
ipv6
vpn-instance-name ]
jp-pkt-size size
pim vpn-instance
[
interface-type
pim timer join-prune
pim vpn-instance
[
360
Remarks
N/A
By default, the interval to send
hello messages is 30 seconds.
By default, the interval to send
join/prune messages
seconds.
NOTE:
This configuration takes effect
after the current interval ends.
By default, the joined/pruned
state holdtime timer
seconds.
By default, the IPv6 multicast
source lifetime is 210 seconds.
Remarks
N/A
N/A
The default setting is 30 seconds.
The default setting is 5 seconds.
The default setting is 60 seconds.
This configuration takes effect
after the current interval ends.
The default setting
seconds.
Remarks
N/A
N/A
The default setting is 8100 bytes.
is 60
is 210
is 210