Mld Configuration Examples; Basic Mld Features Configuration Examples - HP MSR1002-4 Configuration Manual

Task
Clear dynamic MLD multicast group entries.

MLD configuration examples

Basic MLD features configuration examples

Network requirements
As shown in
•
OSPFv3 and IPv6 PIM-DM run on the network.
•
VOD streams are sent to receiver hosts in multicast. Receiver hosts of different organizations
form stub networks N1 and N2. Host A and Host C are multicast receiver hosts in N1 and N2,
respectively.
•
MLDv1 runs between Router A and N1, and between the other two routers (Router B and
Router C) and N2.
•
Router A acts as the MLD querier in N1. Router B acts as the MLD querier in N2 because it has
a lower IPv6 address.
Configure the routers to meet the following requirements:
•
The hosts in N1 can only join IPv6 multicast group FF1E::101.
•
The hosts in N2 can join any IPv6 multicast groups.
Figure 88 Network diagram
IPv6 PIM-DM
Configuration procedure
1. Assign an IPv6 address and prefix length to each interface, as shown in
shown.)
Figure 88:
GE1/0/1
3000::12/64
Router A
Querier
GE1/0/1
3001::10/64
Router B
GE1/0/1
3001::12/64
Router C
Command
reset mld [ vpn-instance vpn-instance-name ] group { all
| interface interface-type interface-number { all |
ipv6-group-address [ prefix-length ] [ ipv6-source-address
[ prefix-length ] ] } }
Receiver
Host A
N1
Host B
Receiver
Host C
N2
Host D
317
Figure 88. (Details not