Mounting On A Standard Or Versatools Rack Shelf; Back Of The Rack Mounting - Extron electronics SW DVI A Series User Manual

Installation, cont'd

Mounting on a standard or VersaTools rack shelf

1. If feet were previously attached to the bottom of the
SW2/SW4, remove them.
2. Mount the SW DVI A Series switcher on the rack shelf,
using two 4-40 x 3/16" screws in opposite (diagonal)
corners to secure the unit to the shelf (see the figures below
HalfRackVersaToolsShelf
and on the next page).
3. Install blank panel(s) or other unit(s) on the rack shelf as
desired.
4. Install the shelf in the rack.
The following illustrations show examples of how the
SW2/SW4 can be mounted on different sized rack shelves.
VersaTools Rack Shelf
4
3
1/2 Rack Width Front
False Faceplate
2
Use 2 mounting holes on
opposite corners.
Mounting an SW DVI A switcher on a 3.5-inch deep
VersaTools rack shelf
2-4 SW DVI A Series • Installation
(2) 4-40 x 3/16"
Screws
HalfRackVersaToolsStandardShelf
1U Universal Rack Shelf
4
3
Front false
faceplate
uses 2
screws.
2
Use 2 mounting holes on
opposite corners.
Mounting an SW DVI A switcher on a standard
9.5-inch deep rack shelf

Back of the rack mounting

The SW DVI A series can also be mounted vertically to the front
or rear rack supports, using the optional MBB 100 Back of the
Rack Mounting Kit (part #70-367-01) as follows:
1. If rubber feet were previously attached to the bottom of the
unit, remove them.
2. Remove the two screws from one side of the switcher.
Retain the screws for possible later reassembly.
3. Attach one bracket to the side of the unit, using the longer
screws included in the mounting kit (see the illustration on
the next page).
SW DVI A Series • Installation
1/2 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
2-5