Custom Panels; I C E | Water Di Spen Ser - Sub-Zero ICBBI-36R Design Manual

BUI LT-I N R E FR IG ERATIO N

Custom Panels

FLUSH IN S E T PAN E L S
The flush inset application is an overlay model with flush
inset panels. It is not a separate model.
The flush inset design allows custom panels to be installed
flush with adjacent cabinets. Similar to overlay, flush inset
panels are typically created by combining a 19 mm custom
panel, a 3 mm spacer panel and a 6 mm backer panel. Refer
to the illustrations for overlay panels. Panels must be fixed
together prior to installation.
For flush inset panels thicker than 19 mm, a 90° door stop
may be required to prevent interference with adjacent
cabinets. Refer to the full-scale templates at the end of this
guide.
When installing two units side by side, refer to page 18 for
dual flush inset installations.
subzero-wolf.com.au

I C E | WATER DI SPEN SER

For model ICBBI-48SD, the refrigerator door panel must
include a cut-out to accommodate the external dispenser.
The thickness of the panel in this area can range from 6 mm
to a maximum of 29 mm. Refer to the illustrations below.
16 mm
2 mm
160 mm
3 mm
RADIUS
327
mm
Dispenser dimensions.
51
mm
HANDLE
GLASSWELL
25
mm
Handle placement.
|
13