Custom Panels - Sub-Zero BI-36UID/O-LH Installation Manual

PANE L I NS TA L L AT I O N

Custom Panels

For overlay and flush inset applications, custom door and
grille panels must be installed. Panel size is critical for a
proper fit. To verify panel requirements and dimensions,
refer to the Sub-Zero design guide at subzero.com/specs.
Flush inset applications require a
IMPORTANT NOTE:
minimum 1 / " reveal on all sides.
(13)
2
Finish all sides of custom panels. They may be visible
when the door is open or through the window of glass door
models.
EXTER N AL D ISPEN S ER
For external dispenser models, the dispenser bezel must be
removed before custom panels can be installed.
The bezel will accommodate a
applications and a 3 / " thick panel for overlay and flush
(19)
4
inset applications. Panels thicker than
routed in the dispenser area to 1
and spacer panels).
To remove the bezel:
Lift, rotate and remove the tray.
1
Lift and remove the grille.
2
Remove the screw from the center of the chute and
3
remove the chute.
Rotate the control panel downward and disconnect the
4
wire harness.
Remove the screws from each corner of the bezel and
5
pull the bezel forward.
TRAY
GRILLE
Tray and grille removal.
1 / " thick panel for framed
(6)
4
3
/ " must be
(19)
4
1 / " (including backer
(29)
8
CHUTE
Dispenser bezel removal.
|
subzero.com 13