Table of Contents
Advertisement
Chapter 2 TL1 Reference
Retrieve E1/2048 kHz Output Parameters
Retrieve E1/2048 kHz Output Parameters
This command returns the settings for the E1/2048 kHz Output module or port
designated by the aid.
Syntax
RTRV-PRMTR-OUTE12048:[tid]:[aid]:ctag;
Parameter
[aid]
Response Format
When the aid specifies a port, the format for each line is:
^^^"aid:mode,bypass,zs,signal,pstate,squelch,crc,ssm,bit"<cr lf>
where:
= port access identifier
aid
= multiframe selection [CAS | CCS]
mode
= allow Clock C selection: [ON | OFF]
bypass
= zero suppression [ON | OFF]
zs
= port signal type [E1 | 2048]
signal
= port state [ON | OFF]
pstate
= threshold value [0 | 1 – 16] (where 0 = disabled). If the reference clock
squelch
PQL exceeds this value, then the output is turned off.
= error checking [ON | OFF]
crc
= Sync Status Messaging enabled [ON | OFF]
ssm
= bit number [4 – 8] of the Time Slot 0 word used for the E1 sync status
bit
message
When the aid specfies a module, then the response is four lines as follows:
^^^"aid: mode,bypass,zs,crc,ssm,bit"<cr lf>
^^^"aid:signal1,signal2,signal3,...signal20"<cr lf>
^^^"aid:pstate1,pstate2,pstate3,...pstate20"<cr lf>
^^^"aid:squelch1,squelch2,squelch3,...squelch20"<cr lf>
54
SSU-2000e Technical Reference
Value
Retrieves the parameters from all E1/2048 kHz Output
ALL
modules in the shelf.
Retrieves parameters from the specified E1/2048 kHz
SxAy[-z]
Output module [or port].
Description
12713140-003-2 Revision E.01 – January 2007
Advertisement
Table of Contents
