Set Date And Time - Symmetricom SSU-2000e Technical Reference

Set Date and Time

This command changes the date and time in the Communications module. All
timestamps are affected by this change. The SSU-2000e system clock shall be set
to the received date and time and a complied message shall be returned, with the
new date/time in the header. If the unit has time set by GPS or NTP client, the
DENY response is returned.
Syntax
SET-DAT:[tid]::ctag::date,time,offset;
Parameter
date
time
offset
Response
The SSU-2000e clock is set to the received date and time and a complied message
is returned, with the new date/time in the header.
Related Commands
Retrieve Header, on page 65
12713140-003-2 Revision E.01 – January 2007
Format
Specifies the date.
yy-mm-dd
Specifies the time.
hh:mm:ss
Sets the local time difference between local and UTC
+/-hh:mm
time. If the local time is ahead of UTC, then use a
positive number; if the local time is behind UTC, then use
a negative number. The valid range is +/– 13 hours.
Chapter 2 TL1 Reference
Set Date and Time
Description
SSU-2000e Technical Reference 127