Rear Panel I/O Ports; 12V Dc-In (Default) - Bt161 - DFI BT160 User Manual

Rear Panel I/O Ports

DC-in
VGA
USB 2.0
USB 3.0
The rear panel I/O ports consist of the following:
• 1 12V DC-in jack (default) or 4-pin power connector (optional) - BT161
• 1 Serial COM port
• 1 VGA port
• 2 RJ45 LAN ports
• 1 USB 2.0 port
• 1 USB 3.0 port
Chapter 2 Hardware Installation
Chapter 2
LAN 1 LAN 2
COM 1

12V DC-in (default) - BT161

DC-in
This jack provides maximum of 100W power and is considered a low power solution. Connect
a DC power cord to this jack. Use a power adapter with 12V DC output voltage. Using a volt-
age higher than the recommended one may fail to boot the system or cause damage to the
system board.
The 12V DC-in jack on the system board co-lays with a 4-pin power connector (optional) as
the figure displayed below.
4-pin Power
1 3
+12V
Ground
Ground
+12V
2 4
21
DC-in jack
www.dfi .com