Front Panel Connector; Chassis Intrusion Connector - DFI BT160 User Manual

Front Panel Connector

HDD-LED - HDD LED
This LED will light when the hard drive is being accessed.
RESET-SW - Reset Switch
This switch allows you to reboot without having to power off the system.
PWR-BTN - Power Switch
This switch is used to power on or off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light. When the system is in the S1 (POS - Power
On Suspend) state, it will blink every second. When the system is in the S3 (STR - Suspend To
RAM) state, it will blink every 4 seconds.
Pin Pin Assignment
3 HDD Power
HDD-LED
5 Signal PWR-LED
7 Ground
9 RST Signal
RESET-SW
PWR-BTN
11 N.C.
Chapter 2 Hardware Installation
Chapter 2
12 11
RESET-SW
PWR-BTN
Front
HDD-LED
Panel
PWR-LED
2 1
Pin Pin Assignment
2 LED Power
4 LED Power
6 Signal
8 Ground
10 Signal

Chassis Intrusion Connector

The board supports the chassis intrusion detection function. Connect the chassis intrusion
sensor cable from the chassis to this connector. When the system's power is on and a chassis
intrusion occurred, an alarm will sound. When the system's power is off and a chassis intrusion
occurred, the alarm will sound only when the system restarts.
26
Chassis
Intrusion
1 2
www.dfi .com