Ip Network Services Required Information - Polycom DOC2560A Getting Started Manual

IP Network Services Required Information

When installing an RMX unit, these default IP addresses must be
modified to your local network settings. Therefore it is important that
before powering the RMX unit up for the first time, that you obtain the
information needed to complete the Local Network Settings section of
the table from your network administrator.
For RMX 1500, the network administrator should allocate three IP
addresses in the local network for an MCU with a MPMx card.
For RMX 2000, the network administrator should allocate four IP
addresses in the local network for an MCU with one MPM/MPM+/MPMx
card and five IP addresses for an MCU with two MPM/MPM+/MPMx
cards.
For RMX 4000, the network administrator should allocate four IP
addresses in the local network for an MCU with one MPM+/MPMx card
and up to seven IP addresses for an MCU with up to four MPM+/MPMx
cards.
Table 2-1 Network Equipment and Address Information
Parameter
Control Unit
IP Address
Control Unit
Subnet Mask
Default Router IP
Address
Shelf Management IP
Address
Signaling Host IP
address
Media Board IP
address (MPM 1)
Media Board IP
address (MPM 2)
RMX 2000/4000 only
Polycom RMX 1500/2000/4000 Getting Started Guide
Factory Default
192.168.1.254
255.255.255.0
192.168.1.1
192.168.1.252
–
–
–
Local Network Settings
2-3