Bicycle Preparation - SRAM RockShox Reverb Stealth Manual

B i c y c l e P r e p a r a t i o n
Secure the bicycle in an upright position.
1
Reverb™ Stealth: The seatpost will be removed from the
bicycle. Do not clamp the seatpost in a bicycle work stand.
Raise the seatpost to the fully extended position.
2
Set the speed adjuster to the full slow position.
3
Rotating the speed adjuster to the slowest setting is critical for a
successful bleed. Failure to do so may result in insufficient fluid
volume inside the hydraulic remote system.
Standard Remote: Turn the speed adjuster knob in the opposite
direction of the arrow (counter-clockwise) until it stops.
Reverb 1x Remote: Remove the remote boot and rotate it out of the
way. Turn the speed adjuster bolt (counter-clockwise) until it stops.
Standard Remote
T25 TORX®
Standard Remote
Reverb 1x™ Remote
1x Remote

Bicycle Preparation

9