SRAM RockShox Reverb Stealth Manual page 21

Mark the cut location.
3
Cut the hydraulic hose.
4
To ensure a square cut and to prevent damage to the hose, use only a
hydraulic hose cutter.
Thread the remote lever hose barb into the hydraulic hose. Hold the
5
end of the hose and rotate the remote lever clockwise while pushing
the remote lever barb into the hose. Stop when the hose is hand tight
on the hose barb.
Do not over-tighten and strip the threads inside the hydraulic hose. If
the hose is over or under tightened, hydraulic fluid can leak.
This concludes the hose replacement procedure for the RockShox®
Reverb™ Stealth and Reverb adjustable height seatposts.
The hydraulic remote system must be bled after a new hose is in-
stalled. Proceed to Remote System
Reverb 1x™ Remote Upgrade Kit: The Reverb 1x Remote upgrade lever
does not contain hydraulic fluid. The hydraulic remote system must be
bled after a new Reverb 1x Remote lever is installed for the first time.
Proceed to Remote System
NOTI CE
NOTI CE
Bleed.
Bleed.
Marker
Hydraulic Hose Cutters
Needle nose pliers Standard Remote
Reverb 1x Remote
Needle nose pliers
Hose Sizing and Remote Installation 21