SRAM RockShox Reverb Stealth Manual page 32

With the syringe plunger extended, hold the Bleeding Edge™ tool and
7
gently but firmly, remove it from the bleed port.
Do not pull the syringe or hose. This could cause separation and loss
of fluid.
Do not rock the Bleeding Edge tool side to side. This could damage the
tool and remote.
Absorb and remove any excess fluid from the bleed port with a rag.
8
Test remote hydraulic pressure: Press and release the remote lever
9
five or six times and confirm the lever retracts slowly and smoothly with
no gaps in pressure.
Observe the bleed port. If fluid leaks from the bleed port when the
lever is pressed and released, the bleed port is not closed properly. If
fluid is visible, insert the Bleeding Edge tool and tighten the bleed port
before proceeding.
Confirm fluid is not leaking from either end of the hose when the
actuator is depressed. If a leak is detected, the hose must be tightened
and the bleed procedure may need to be repeated.
Turn the speed adjuster clockwise until it stops. This is the fastest
10
speed setting.
NOTI CE
Bleeding Edge Tool
T25 TORX®
Remote Bleed - Reverb™ 1x™ Remote 32