Setting Up The Instrument; General Information - wtw Turb 555 Operating Manual

Turb 555 / Turb 555 IR
ba41113e07 04/2009
4.5

Setting up the instrument

4.5.1 General information

In the normal measuring mode, you can adjust the Turb 555
/Turb 555 IR to your requirements using the setup function
at any time. You can alter the following settings:
Measuring procedure / measured unit
Ratio method (on or off)
Resolution
Code function (on or off)
Calibration and setup code
Periodical output of measured values to the RS232 inter-
face (on or off)
Output interval of the periodical measured value output
Baud rate of the RS232 interface
Calibration interval (1 - 180 days)
After the selected calibration interval has expired, the Cal
indicator appears on the display until the measuring in-
strument is recalibrated.
Date
Time
The settings remain stored in the instrument.
Note
Settings are made in this measuring instrument following a
compelled guidance. If you have called up the setting func-
tion once, you can only leave this function if you have run
through all the settings one after the other with the
key, until END is displayed in the lower display line. Then
1
confirm with the
normal measuring mode. You can switch off the instrument
only after you have left the setting function.
key. The instrument returns to the
Operation
4 6
or
47