wtw Turb 555 Operating Manual page 52

Operation
Periodical measured
value output
52
20 Repeat the steps 12 to 18.
21 Confirm the setup code with
The next setup menu appears (
In the following menu, you can switch the periodical mea-
sured value output to the RS232 interface on and off, and
you can set the output interval (
more information on outputting measured values, see sec-
tion 4.6.2.
8
22 With the
val.
Options: OFF -> 5 SEC -> 30 SEC -> 1 MIN ->
5 MIN -> 15 MIN -> 30 MIN -> 1 HR
23 Confirm your selection with
The next setup menu appears (INT).
When you have switched on the periodical measured value
output, the menu to set the baud rate appears (steps 24 to
25). If you want to keep the existing baud rate, press
1
stead of . In this case, the next setup menu (INT) will
appear immediately.
Note
When the periodical measured value output is switched on,
the function to output current measured values by pressing
1
the key is blocked.
p
2
or key select the required output inter-
1
Turb 555 / Turb 555 IR
1
.
p
).
is displayed). For
.
ba41113e07
6
in-
04/2009